ML7105-00x

---

For customers designing LAPIS Semiconductor

Please refer to LAPIS Semiconductor Bluetooth® SMART LSI official site for additional information.
Items to Confirm (designing of oscillation circuit)
Selection Guidance for crystal unit
Crystal Products Lineup
Oscillation Circuit and Selection Guidance of Crystal Unit.
Precautions for designing of PCB Board
Crystal Recommendations for LAPIS Semiconductor “ML7105-00x family”.
Recommendations ML7105-00x family.

Items to Confirm (designing of oscillation circuit)

Please note: to design oscillation circuit, you need to confirm the electronic characteristics as follows:

Oscillation allowance and Negative resistance (-R):
You need to confirm oscillation capability.
We recommend the condition: (-R) / ESR > 5
* -R: Negative resistance, ESR: Equivalent Series Resistance
Drive Level:
You need to confirm if oscillation is stable, and if the drive level is within the specification.
Load Capacitance:
Load capacitance affects frequency stability, oscillation allowance, negative resistance, and start-up time of oscillation.
In addition the load capacitance is determinative factor of crystal unit's load capacitance (CL value) directly.
* frequency stability: frequency deviation out of circuit conditions.

Selection Guidance for crystal unit

When Customer selects crystal unit, ｌload capacitance (CL value) is an important factor of the selection.
For instance, crystal with small CL(7.0 pF) makes larger oscillation allowance, smaller current consumption and worse frequency stability, like below table.
Oppositely, crystal with large CL(12.5 pF) makes smaller oscillation allowance, larger current consumption and better frequency stability.
Please select it in consideration of these characteristics.

StrongFirst Crystal Product Lineups

Oscillation Circuit and Selection Guidance of Crystal Unit for ML7105-00x micro controller

26MHz Crystal

32.768 kHz Crystal

Notes:

· *1 Load Capacitance

· *2 Above recommendations are based on actual evaluation results and intended to support users in picking the right components. And the results are only according to the sample set that received from our customers, so it is not including the dispersion trend of IC and the external parts.
As the actual board layout and choice of external components influences the best suitable crystal load capacitance, We do not assume any responsibility and grant warranty for above recommendations. Users design must be verified and decided by own and individual evaluation.

Precautions for designing of PCB Board

-Please lay out crystal unit, capacitor and resistor near ML7105-00x as far as possible.
-Please connect pins within 20mm length, and do not cross other signal lines.

-Please lay out GND line pattern under crystal unit.
-In case of multi-layered PCB board, do not lay out other signal lines under crystal unit.

---