K6x Family

---

For customers designing NXP Semiconductors

We are pleased to introduce you to our crystal unit

· Items to Confirm (designing of oscillation circuit)

· Selection Guidance for crystal unit

· Crystal Products Lineup

· Oscillation Circuit and Selection Guidance of Crystal Unit.

· Precautions for designing of PCB Board

Crystal Recommendations for NXP Semiconductors "Kinetis K Families".

· Recommendations Kinetis K Family.

Items to Confirm (designing of oscillation circuit)

Please note: to design oscillation circuit, you need to confirm the electronic characteristics as follows:

Oscillation allowance and Negative resistance (-R):
You need to confirm oscillation capability.
We recommend the condition: (-R) / ESR > 5
* -R: Negative resistance, ESR: Equivalent Series Resistance
Drive Level:
You need to confirm if oscillation is stable, and if the drive level is within the specification.
Load Capacitance:
Load capacitance affects frequency stability, oscillation allowance, negative resistance, and start-up time of oscillation.
In addition the load capacitance is determinative factor of crystal unit's load capacitance (CL value) directly.
* frequency stability: frequency deviation out of circuit conditions.Selection Guidance for crystal unit

When Customer selects crystal unit, ｌload capacitance (CL value) is an important factor of the selection.
For instance, crystal with small CL(7.0 pF) makes larger oscillation allowance, smaller current consumption and worse frequency stability, like below table.
Oppositely, crystal with large CL(12.5 pF) makes smaller oscillation allowance, larger current consumption and better frequency stability.
Please select it in consideration of these characteristics.

StrongFirst Crystal Product Lineups

Oscillation Circuit and Selection Guidance of Crystal Unit for Kinetis K Application processor

1) 32kHz

Internal programmable capacitors : 0 (RTC control register=0, default)

2) MHz

Internal programmable capacitors : 0 (RTC control register=0, default)

Notes:*

1. Load capacitance.

2. Two digits of the product code is packing specification, please refer here for the detail.

3. Above recommendations are based on actual evaluation results and intended to support users in picking the right components. As the actual board layout and choice of external components. As the actual board layout and choice of external components influences the best suitable crystal load capacitance, We does not assume any responsibility and grant warranty for above recommendations. Users design must be verified and decided by own and individual evaluation.

Precautions for designing of PCB Board

-Please lay out crystal unit, capacitor and resistor near Kinetis K family as far as possible.
-The length of signal patterns in oscillatiton circuit should be as short as possible, and do not cross other signal lines.

For 32kHZ Crystal Unit

-Please lay out GND line pattern under crystal unit.
-In case of multi-layered PCB board, do not lay out other signal lines under crystal unit.

---